User's Manual

Installation Manual Appendix D-9
LED14 Status: Red, three Tx wand antennas
In a three Tx Wand antenna system, LED1, LED2 and LED3 should illuminate alternatively.
1. Make sure jumper JP4 is in position 1-2
If LED1 (“X” antenna indicator), LED2 (“Y” antenna indicator) and LED3 (“Z” antenna
indicator) are not illuminating alternatively:
2. Check the “X”, “Y” and “Z” Tx Wand antennas for:
 Metal nearby (in wall or objects)
 Damage
 Proper Wiring
(page 4-4)
 Proper Tuning
(page 4-7)
If LED 1, 2 and 3 are not illuminating alternatively and LED3 is bright:
3. Reconnect P2 (Receiver) on the Controller
4. Move jumper JP5 to position 1 and wait 20 seconds
If LED3 goes off, reset jumper JP5 and potentiometer R26 to their proper settings
(see Appendix
for info on JP5 and R26)
If LED3 remains Red, Consult your Accutech Representative.