User's Manual

D-8 Appendix Installation Manual
LED14 Status: Red, two Tx Wand antennas
In a two Tx wand antenna system, LED1 and LED2 should illuminate alternatively.
1. Make sure jumper JP4 is in position 2-3
If LED1 (“X” antenna indicator) and LED2 (“Y” antenna indicator) are not illuminating
alternatively:
2. Check the “X” and “Y” Tx Wand antennas for:
 Metal nearby (in wall or objects)
 Damage
 Proper Wiring (page 4-4)
 Proper Tuning (page 4-7)
If LED1 and LED2 are not illuminating alternatively and LED2 is bright:
4. Reconnect P2 (Receiver) on the Controller
5. Move jumper JP5 to position 1 and wait 20 seconds
If LED2 goes off, reset jumper JP5 and potentiometer R26 to their proper settings
(see Appendix
for info on JP5 and R26)
If LED2 remains Red, Consult your Accutech Representative.