User's Manual

Installation Manual Appendix D-7
LED14 Status: Red, one Tx Wand antenna
If LED1 is dim or off:
1. Check the “X” Tx Wand antenna for:
 Damage
 Proper Wiring
(page 4-4)
 Metal nearby (in wall or objects)
 Proper Tuning
(page 4-7)
If LED1 is bright:
2. On the Controller, reconnect P2 (Receiver)
3. Move jumper JP5 to position 1 and wait 20 seconds
If LED1 goes off, reset jumper JP5 and potentiometer R26 to their proper settings
(see Appendix
for info on JP5 and R26)
If LED1 remains Red, Tx wand antenna may be faulty; swap with known working or spare
If still a problem, consult your Accutech Representative