User's Manual

D-6 Appendix Installation Manual
LED14 Status: Yellow
When LED14 displays Yellow it indicates a Tx wand antenna problem and a Receiver-related
problem. Follow the Green section first (to rule out a Tx wand antenna problem) and then, if
necessary, the Red section second.
LED14 Status: Green
When LED14 displays Green it indicates a Receiver-related problem.
To remedy this condition, use the following instructions:
1. Check for and remove any Tags that are in the zone or adjacent zones
2. On the Controller, move jumper JP5 to position 1 and wait 20 seconds
NOTE:
If system is working properly, LED14 will flash Green once every 8 seconds.
If the system in not working properly, LED 14 will be steady Green for 8 seconds and
then off for one second.
If LED14 continues to be Green for 8 seconds and then off for one second:
4. On the Receiver, check potentiometer R19 for proper setting (page 5-6)
If LED14 continues to be Green for 8 seconds and then off for one second:
5. Receiver may be faulty; swap with known working or spare
6. If still a problem, consult your Accutech Representative