User's Manual

Installation Manual Appendix D-3
Door Ajar indicator alarming
(LED8, steady Red)
Is door propped open? Check
Is door traffic high zone? Extend Door Ajar delay time (see page 22-1)
Is monitored zone an Elevator/Hallway
with a PIR ?
Disconnect Door Ajar feature by removing
wire to Receiver on both ends
Loiter indicator alarming (LED9, steady Yellow)
Is patient in monitored zone? Address situation
Is patient in room next to monitored zone? Reduce Tx wand antenna sensitivity (page 4-7)
No functions working
If none of these features are working… Check output on Controller with DMM.
If outputs are good, check wiring and
connections.
If any outputs are not functioning, Controller
may need replacing.