User's Manual

6-6 The Tag Installation Manual
Testing Tags
For maximum protection of residents or
assets, Accutech recommends that Tags be
tested on a weekly basis.
There are 6 ways that you can test Tags:
 Enter a monitored zone
(Software will report.)
 With a TAD
 With a PTAD
 The Keypad’s Auxiliary LED
(Yellow) will light when a Tag is
detected (Optional; additional wire
required).
 Check Visual Pulse LED if present
 BR and CB Tags only - Remove
Band Removal band or Cut Band
band (alarm will sound
)
Tag and Band Maintenance
 Cleaning of Tags
 Cleaning of Bands
 Storage of Tags and Bands
Cleaning of Tags
All Tags are reusable but they must be
cleaned and sanitized between applications.
In long-term applications, periodically
replace the bands and clean the Tags.
There are a few methods that can be used to
clean and sanitize Tags:
HOWEVER, DO NOT:
 DO NOT submerge Tags in water
 DO NOT soak Tags in water
 DO NOT submerge Tags in cleaning
solutions
 DO NOT soak Tags in cleaning
solutions
 DO NOT use solvents
 DO NOT use abrasive cleaners or cloths
 DO NOT put Tags in an AutoClave
 DO NOT put Tags in a dishwasher
 DO NOT steam clean Tags
 DO NOT put Tags in a washing
machine or dryer
Acceptable Tag Cleaning Methods:
 Antibacterial wipes
(wipe only, DO NOT soak)
 Hydrogen peroxide (wipe only
from cloth, DO NOT submerge or
soak)
Cleaning of Bands
All Tag bands are one-time use only. In
long-term applications, periodically replace
the bands and clean the Tags.