User's Manual

5-4 the Receiver Installation Manual
Receiver Jumpers
NOTES:
Receiver Jumpers JP1 through JP5 are set to
factory defaults when you receive them. The
default settings have been determined by the
most common usage. Some facilities may have
different requirements. Please consult your
Accutech Representative before altering jumper
positions.
 Jumper Definitions
 IS 3200 Zone Receiver jumper settings
 BR 4200 Zone Receiver jumper settings
 BR 4200 Auxiliary Receiver jumper settings
The following tables (Tables 5.1 – 5.4) contain
the Receiver jumper definitions and default
positions for each system. Refer to Figure 5.6
for the locations of the Receiver jumpers.
Jumper JP4 sends status data upon a change in a
Tag’s status. This includes Band Removal, Low
Battery, and/or Wet Band.
Table 5.1
Jumper Definitions
Jumper Sends Status Data Upon…
JP1 Any 418MHZ Signal
JP2 Rx Supervise Events
JP3 Valid Zone Tag Detections
JP4 Change in Tag status
JP5 Zone Reset Events
Connecting the Receiver
Whether internally or externally mounted, the
wire connections from the Receiver to the
Controller are the same. See Figure 5.7 for the
proper wire connections.
Table 5.2
IS 3200 Zone Receiver jumper settings
JP1 Off
JP2 Off
JP3 Off
JP4 On
JP5 On
NOTE: The internally mounted Receiver is
provided with a factory-installed interconnect
cable. There should be no reason to ever
disassemble it. If however it should need
replacement for any reason simply use an 18-
inch piece of 22 gauge 12-conductor non-
shielded cable. Follow the color code in Figure
5.7.
Table 5.3
BR 4200 Zone Receiver jumper settings
JP1 Off
JP2 Off
JP3 Off
JP4 On
JP5 On
Table 5.4
BR 4200 Auxiliary Receiver jumper settings
JP1 Off
JP2 Off
JP3 Off
JP4 On
JP5 Off
Figure 5.6 Receiver jumper locations