User's Manual

4-4 The Tx wand antenna Installation Manual
Connecting a Tx wand antenna
to the zone Controller
To connect a Tx wand to the zone Controller,
refer to Figure 4.5 (
and if applicable, Figures 4.6
and 4.7
) and use the following instructions:
1. Using the RED wire, connect the
“UNREG” on the antenna (pin P1-2)
to “UNREG” on the zone Controller
(pin P1-5).
NOTE: When multiple antennas are
being used, each subsequent antenna
should have its RED wire connected
to one of the two “UNREG” positions
on the zone Controller (P1-1 or P1-5).
2. Using the BLACK wire, connect the
“ANT” on the antenna (pin P1-1) to
“X” on the zone Controller (pin P1-2).
NOTE: When multiple antennas are
being used, the second antenna’s
BLACK wire should be connected to
“Y” (pin P1-3) and the third antenna’s
BLACK wire should be connected to
“Z” (pin P1-4).
3. Regardless of how many antennas are
being used, the bare “SHIELD” wire
from each antenna cable should be
tied together and connected at the
“SHIELD” position (pin P1-6) on the
zone Controller. The shields wires are
not to be connected to the antenna.
4. After the antenna(s) are connected and
tuned properly (
see page 4-7), replace
the antenna cover(s).