User's Manual
3-8 The Controller Installation Manual
Tamper Switch
UL 294 requirements call for the installation
of a “tamper switch” that engages the lid,
and is wired so as to cause an alarm if the lid
is removed.
When the tamper switch is installed and the
lid is removed, a Tx Supervise alarm will be
generated and LED14 will illuminate red.
To remedy the alarm, replace the lid.
The switch is mounted with #4-40, ½”
machine screws, star washer, and nut to the
Controller case (Figure 3.4).
To wire the tamper switch, use
Figures 3.3 - 3.4 and the following
instructions:
1. The BLACK wire of the tamper
switch goes to the “X” Tx wand
antenna at the “Antenna” terminal
(Figure 3.3).
2. The WHITE/BLUE wire of the
tamper switch goes to the “X”
terminal of the Controller (P1-2).
(Figure 3.4)
Figure 3.3
Tamper Switch antenna connection