User's Manual
Installation Manual The Accutech Systems 1-13
Typical System Configurations
Single Door Example
Remote Single Door Example
Double Door Example
6 to 8 foot Elevator Example
The following are lists of the components used in each of the more typical zones encountered. They are
accompanied by graphics that are intended merely as suggestions as to where the components should be
placed in relationship to the opening being covered. They are shown with a “drop” ceiling, where it is
typically easy to access an “out of the way” area.
The chapters that follow will more clearly define the parameters used to determine component locations.
As always, common sense, local codes, and consultation with your Accutech Representative will go a
long way toward answering many of your questions.
Single Door Example
(Figure 1.29)
(Controller mounted at door, above drop ceiling)
1-Accutech Controller/Receiver (Ch. 3; Ch 5)
1-Accutech Tx wand antenna
(Ch. 4)
1-Magnetic Switch
(Ch. 9)
1-Keypad
(Ch. 7)
1-Local Alarm
(Ch. 13)
1-Cable Kit
(Ch. 2)
Figure 1.29 Single Door Example
Remote Single Door Example
(
Figure 1.30)
(Controller mounted remotely, in utility room)
1-Accutech Controller (Ch. 3)
1-Remote Receiver
(Ch. 5)
1-Accutech Tx wand antenna
(Ch. 4)
1-3101 Magnetic Lock
(Ch. 11)
1-Magnetic Switch
(Ch. 9)
1-Keypad
(Ch. 7)
1-Local Alarm
(Ch. 13)
1-Cable Kit
(Ch. 2)
1-Junction Box
1-Composite Cable (specify length)
(Ch.2)
Figure 1.30 Remote Single Door Example