User's Manual

Installation Manual The Accutech Systems 1-1
The Accutech Systems
 ES 2200 System
 IS 3200 System
 BR 4200 System
 Cut Band System
 How Accutech Systems Work
 System Components
 Typical System Configurations
Throughout this manual, when referring to the
various applications of the system, the term
“Tag” is used to represent all possible
applications of the system (i.e., a resident, a
patient, an infant, pediatrics, or an asset, etc.)
Furthermore, the terms “ingress” and “egress”
will be encountered. They are another way of
saying “coming and going” or “entering and
exiting” respectively.
The ES 2200 System is our platform system
from which all Accutech System’s are built.
Each subsequent system adds on to the system
before. Each system can be easily upgraded as
facility needs change and technology advances.
ES 2200 System
The function of the ES 2200 System is to alert
facility personnel of the possible egress of a
monitored resident.
The ES 2200 can be utilized for special care
residents suffering from wandering malady or
tendencies of straying into unauthorized areas or
leaving a facility, pediatric patients, asset
security and/or low-cost infant security. The
system is designed so that each monitored door
is a stand-alone system.
The ES 2200 System consists of a Controller, a
Transmit (Tx) wand antenna, a Receiver, a
Magnetic Switch, a Keypad, a Local Alarm, and
an ES 2200 System Tag (
LT/SB22).
When a Tag enters a monitored area, the system
can automatically:
 lock doors
 deactivate elevators
 sound alarms
 flash lights
 trigger visual displays (e.g., SAPs or GDPs)
The Controller can be mounted on the wall near
the point of egress or can be mounted out of
sight in a utility or equipment closet.
A Tx wand antenna is typically mounted on the
wall at the point of egress. However, in some
cases it is possible to mount the Tx wand
antenna at the zone so that it is not seen.
The Receiver is mounted internally (inside the
Controller) when the Controller is located at the
zone or externally (near the monitored area)
when the Controller is located remotely.
Virtually any hallway, doorway or elevator can
be made to sense the approach of monitored
resident, and then trigger audial and/or visual
alarms to prompt a staff response.
By adding options, such as the Magnetic Lock or
an Elevator Deactivation Unit, most egress
opportunities can be eliminated without
restricting staff, visitors and non-monitored
residents access.
Additional options such as the Loiter alarm,
Door Ajar alarm, Local alarms, Central alarms,
Passive Infrared Readers (PIRs), Staff Alert
Panels (SAPs), and Graphic Displays Panels
(GDPs) further enhance your ability to prevent
unescorted egress.