User's Manual

Installation Manual the Multiplexer 17-3
Multiplexer Jumpers
The three Multiplexer jumpers, JP1-3 (Figure
17.1
), should remain in place for the unit to
function properly.
Wiring the Multiplexer
 To the Power Supply
 From Receivers
 To GDP
 To PC
 To other Multiplexers
To the Power Supply
Using RED and BLACK wire, connect the +12V
and Ground between the Power Supply terminal
strip and the Multiplexer (
P12 pins 1 and 2).
From Receivers
NOTE: When connecting Receivers to the
Multiplexer, their input positions on the
Multiplexer are determined by (
and must
match) the software configuration (see the
example configuration on page 19-2
).
To connect a Receiver to a Multiplexer, refer to
Figure 17.2 – 17.3 and use the following
instructions:
1. Up to 8 Receivers can be connected to
one Multiplexer. Connecting a Receiver
to a Multiplexer requires 3 wires.
2. For each Receiver, connect pins 1, 2 and
4 (ID Data, Status Data, and Gnd) to one
input zone (Z1T, Z1S and Z1C) on the
Multiplexer.
NOTE: Do not tie Grounds together
unless they have the same source.
For example, the first Receiver (e.g.,
Zone 1) will connect to Z1T, Z1S, and
Z1C; the second Receiver (e.g., Zone 2)
will connect to Z2T, Z2S and Z2C, and
so on.
NOTE: Only use IN 1-2, IN 3-4, IN 5-6
and IN 7-8 for inputs; do not use IN 9-
10.