User's Manual

15-4 Perimeter Functions Installation Manual
Setting ON/OFF times
To set ON/OFF times for predetermined timer
events, refer to Figure 15.1 and use the
following instructions:
1. To enter the program mode, press and
release the button marked “Timer” once.
NOTE: The LCD will show:
Timer 1 ON --:--
2. Pressing the “Timer” button a second
time will set the unit to OFF timer 1.
NOTE: This sequence will continue for
6 ON timers and 6 OFF timers for a total
of 12 timers.
3. Press and release the “clock” button to
exit the program mode.
Perimeter System
You can also monitor a perimeter door without
the use of a Timer. The door would remain
locked at all times and would require a valid
code entered into a Keypad (to exit) or
activating a PBO (to enter).
To set the Accutech System for this situation, on
the Controller, jumper P8-pin 3 (+12V) to P6-
pin 1 (Per Lock).