User's Manual

Installation Manual Perimeter Functions 15-3
Programming the Timer
 Setting the Time
 Programming for a Day and Time
 Programming for all Week
 Setting ON/OFF times
Programming the Timer requires you to set
event times and whether to turn the system on or
off at those times.
Setting the Time
To set the Timer time, refer to Figure 15.1 and
use the following instructions:
1. Activate the Memory Backup Battery by
switching mode set dipswitch 1 to ON.
NOTE: The LCD will come on flashing
displaying: Off 00:00
2. Apply system power to the FT-100 unit.
3. Press and hold the “clock” button.
4. To set hours, use the button marked
“h+”.
5. To set minutes, use the button marked
“m+”.
6. To set day of the week, use the button
marked “Day”.
7. Release the “clock” button.
Programming for a Day and Timer
To program an ON or OFF instruction for a
particular day and time, refer to Figure 15.1 and
use the following instructions:
1. Select the desired timer (1 thru 6 ON; 1
thru 6 OFF) using the “Timer” button.
2. Program the desired time and day using
the “h+”, “m+” and “Day” buttons.
3. Press and release the “clock” button to
exit the program mode.
NOTE: If a Day is not selected, the action will
occur every day.
Programming for all week
To program an ON or OFF instruction for all
week, refer to Figure 15.1 and use the following
instructions:
1. Select the desired timer (1 thru 6 ON; 1
thru 6 OFF) using the “Timer” button.
2. Program the desired time using the “h+”
and “m+” buttons.
3. Press and release the “clock” button to
exit the program mode.