User's Manual
Installation Manual Elevator Deactivation 14-3
Local or State Code may require the wire to be
run in conduit. Be sure to check your
requirements before beginning work.
NOTE: State codes require that all lock and
elevator deactivation circuitry be wired into the
facility’s fire alarm system. This is done so that
in case of fire, any lock or elevator deactivation
unit disengages, allowing for free egress or
ingress. Be sure to check your local codes and
see Chapter 12 on Fire Panel Interface Units.
Wiring the
Elevator Deactivation Circuitry
For wiring the Elevator Deactivation use 18
AWG (CL2-P), 6-conductor non-shielded
Plenum cable.
To wire the Elevator Deactivation, refer to
Figure 14.1 & 14.2 and use the following
instructions:
1. Using the RED wire, connect K1 (Car
Deactivation) Relay terminal marked
“A” (coil +) to P7-pin2 (the “Alarm
N.O.” terminal) of the Controller.
2. Using the BLUE wire, connect K2 (Call
Button Deactivation) Relay screw
terminal marked “A” (coil +) to P3-pin4
(the “Call N.O.” terminal) of the
Controller.
3. Using BLACK wire, place a jumper
wire between the “B” terminals (Coil-)
of the K1 and K2 Relays.
4. Using the BLACK wire, connect the
screw terminal marked “B” of one of the
Relays to P7-pin1 (the GROUND
terminal) of the Controller.
5. Using the BROWN wire, connect the
right most screw terminal of the 4
position terminal strip located in the
bottom of the cabinet to P5-pin2 (the
“IN” terminal) of the Controller.
6. Using the WHITE wire, connect the
second from the right screw terminal of
the 4 position terminal strip to P5-pin1
(the “Out” terminal) of the Controller.
NOTE: These two terminals in steps 5 &
6 will be used for hookup of the N.C.
dry contact of the second condition
source.
7. At the P3 connector add an 18-gauge
jumper wire from the “Call Comm”
terminal (pin 2) to “+ Volt Out” (pin 1).
8. At the P7 connector add an 18-gauge
jumper wire from the “Fire Volt”
terminal to the “Alarm Comm” terminal.
9. At P4 pins 5 & 6, connect the fire panel
interface contacts (See Chapter 12).