User's Manual

Installation Manual the Push Button Override (PBO) 8-3
Connecting the PBO
to the Controller
You will need 22 AWG, 4 –conductor Plenum-
rated cable for installation.
NOTE: The following instructions assume that
the Keypad and Controller are already wired.
See Chapter 7, page 7-4 for these instructions.
To connect the PBO to the Keypad and
Controller, refer to Figure 8.2 and use the
following instructions:
1. Remove the Keypad from the white
back box.
2. Remove the Controller cover.
3. Jumper all negatives (-) of the three
LEDs together, then to the right prong
of the PBO plug (with a spade crimp
connector), and finally to the BLACK
wire that connects the Keypad to the
Controller.
4. Using RED wire, connect the positive
(+) of the Red LED to the RED wire
that connects the Keypad and the
Controller.
5. Using the GREEN wire, connect the
positive (+) of the Yellow LED to the
GREEN wire that connect the Keypad
and the Controller.
6. Using the WHITE wire, connect (using
a butt splice) the positive (+) of the Red
LED to the WHITE wire that connects
the Keypad and the Controller.