User's Manual

13-6 Alarm Output Devices Installation Manual
2. Using BLACK wire, connect the
negative (-) of the Speaker to the
negative (-) of the Speaker Terminal
Strip on the Central Alarm.
Speaker Volume Control
To adjust Speaker volume, use the potentiometer
located on the bottom end of the Central Alarm .
About the SAP
SAP Specifications
Mounting a SAP
Connecting a SAP to a Controller (up to 8)
A SAP (Figure 13.7), typically located at a staff
station, notifies staff when an alarm occurs in a
monitored zone through a piezo buzzer and
alarm-specific LEDs. The LEDs in the left
column will flash and the LEDs in the right
column will light steady.
Figure 13.7 A SAP example
SAP Specifications
As indicated on the SAP:
Power Requirements
Temperature
A Flashing Red LED means
an Alarm
Weight
Power Requirements
A Flashing Yellow LED means
a Check System
(System Supervisor alarm)
12V DC
Temperature
A Steady Red LED means
a Door Ajar alarm.
A SAP operates best in an ambient temperature
between 35 and 90 degrees Fahrenheit.
Operation outside of this range may cause
unexpected or undesirable results, including
premature failure.
A Steady Yellow LED means
a Loiter alarm.
Weight
A SAP weighs approximately 1 pound.