User's Manual

13-2 Alarm Output Devices Installation Manual
Figure 13.2 The Local Alarm
The Alarm Output Connector
The Alarm Output connector (Figure 13.1) is P9
on the Controller.
Pin 1 is +12V, Pin 2 is Supervisor Alarm out,
and so on.
Local Alarm Specifications
 Power Requirements
 Temperature
 Weight
Power Requirements
12V DC
Temperature
Figure 13.1 The Alarm Output connector
The Local Alarm operates best in an ambient
temperature between 35 and 90 degrees
Fahrenheit. Operation outside of this range may
cause unexpected or undesirable results,
including premature failure.
The Local Alarm
 Local Alarm Specifications
 Mounting the Local Alarm
 Connecting the Local Alarm
 Composite Cable
Weight
The Local Alarm (Figure 13.2; System Sensor
PA400 Series), a 90db at 10 feet piezo-signaling
device, is intended to attract attention near the
monitored zone only.
The Local Alarm weighs approximately 2.5
ounces.
Mounting the Local Alarm
Use a standard 2-1/2” deep single-gang box to
mount the Local Alarm with the two mounting
screws supplied.
Connecting the Local Alarm
You will need 22-gauge, 2-conductor plenum-
rated cable for installation.