User's Manual

8-2 the Push Button Override (PBO) Installation Manual
Mounting the PBO
The PBO is designed to be surface mounted
using the back box provided.
To surface mount the PBO use the following
instructions:
1. Using a screwdriver, separate the PBO
from the back box.
2. Push out the back knock-out.
3. Using the back box as a template, mark
the mounting holes.
4. Drill the necessary holes in the
mounting surface.
5. Secure the back box to the mounting
surface with appropriate hardware.
6. Make any and all wire connections that
require the PBO to be unmounted.
7. Replace the PBO to the back box.
Connecting the PBO to the Keypad
You will need 22 AWG, 4 –conductor Plenum-
rated cable for installation.
NOTE: The following instructions assume that
the Keypad and Controller are already wired.
See Chapter 7, page 7-4 for these instructions.
To connect the PBO to the Keypad, refer to
Figure 8.2 and use the following instructions:
1. Remove the Keypad from the white
back box.
2. Remove the Controller cover.
3. Using the RED wire, connect (with a
spade crimp connector) the left prong of
the PBO plug to pin 5 of the Keypad.
4. Using the GREEN wire, connect (with a
butt splice) the positive (+) of the Green
LED to the GREEN wire that connects
the Keypad and the Controller.