User Manual
Table Of Contents
- LC 1200 Manual (v1.00)
- FCC Statement of Conditions
- Warranty Statement
- How to use this manual
- Table of Contents
- Ch. 1 - The LC 1200 System
- Ch. 2 - The LC unit
- Ch. 3 - Tags & TAD
- Ch. 4 - The Magnetic Switch
- Ch. 5. - Passive Infrared Reader (PIR)
- Ch. 6 - The Keypad
- Ch. 7 - Push Button Override (PBO)
- Ch. 8 - External Sounders
- Ch. 9 - Magnetic Locks
- Ch. 10 - Elevator Deactivation
- Ch. 11 - Automatic Door Deactivation
- Ch. 12 - Fire Panel Interface (FPI)
- Ch. 13 - Timer
- Ch. 14. - Alert Panels
- Ch. 15 - System Maintenance & Testing
- Ch. 16 - FAQ & Troubleshooting
- Appendix A: Component Cut Sheets
- Glossary
- Index
6-6 The Keypad LC 1200 Manual
Programming
Initiating a Keypad Reset/Escort
Programming the master code
Programming user codes
Deleting user codes
Resetting the master code
Adjusting the Keypad Escort Time
PLEASE NOTE:
For complete information about the Keypad,
consult the manufacturer’s manual.
The Keypad provided by Accutech (the Visonic
Ltd. CL-8A; Figure 6.6
) is used to escort residents
through a monitored zone and to reset zone
equipment once an alarm has occurred.
Figure 6.6 The Keypad
Programming the Keypad is, in simple terms,
providing it with a set of instructions on how to
react in various contingencies. The Keypad must
be programmed as soon as all installation and
wiring have been completed. Later on, as
changes take place, partial or full
reprogramming may be carried out as many
times as necessary.
The Keypad’s EEPROM memory can store up to
56 different 1-8 digit user codes, each assigned
to an authorized individual user or to a group of
users.
The Keypad has three LED indicators. See Table
6.1 for their functions during normal operation.
Table 6.1 Keypad LED Indicators
LED Status Function
Green
Off Zone Ready
On* Keypad Reset
or Escort Time
initiated
Yellow
Off No Power or
No Tag
On Power
indicator or
Tag in Zone
indicator
(dependant on
installation)
Red
Off Zone Normal
On Alarm
* During programming, the green LED functions
differently.
Initiating a Keypad Reset/Escort
To initiate a Keypad Reset or the Escort
function, enter a valid user code and press the
[#] key. The green LED will light.
Keypad Resets are used to reset zone equipment
after an alarm has been addressed. When you
initiate a Keypad Reset, all zone equipment and
alarms will be reset. However, if the alarm
condition is not properly corrected, the alarm
will resume.
The Keypad’s Escort function is used to escort
Tags through a monitored zone without
triggering alarms. When you initiate the Escort
function, for the duration of the Escort time, you
will be able to escort the Tag through the door,
hallway, or use an elevator without triggering
alarms.