User's Manual

ID-TAD Programming Mode
If you want to change and or add user codes or a certain function of the ID-TAD you will need to
enter programming mode.
Note: To prevent the screen from timing out and shutting off, press Enter when the display
indicates it is counting down to Power OFF. The display will start with and indicate “20 seconds
to power off”, then “7 seconds to power off” before shutting down.
To Enter Programming Mode:
1. Press: Enter, Enter, Master Code, Enter, (198237645 is the default master code)
To Exit Programming Mode:
1. Press: Power/Clear
Once you have entered the correct Programming Mode, the screen will display a configuration
menu consisting of:
iDTAD Version 0.0.X
1. Configure Buzzer
2. Set Unlock Timeout
3. Set LCD Contrast
4. Change Master Code
5. Edit Unlock Codes
6. Set Defaults
7. Select MBM Display
1. Configure Buzzer, Press 1. This will bring you to a new screen. “Press 1 or 2 to configure
buzzer” is displayed. You will have 2 options.
1. Buzzer for Tag BR
Current: Enabled or Disabled
2. Buzzer for MBM
Current: Enabled or Disabled
To change the Current status of 1. Buzzer for Tag BR, Press 1. The next screen will display the
current status “BR BUZZER ENABLED” or “DISABLED” is displayed with a selection of:
1. Enable
2. Disable
Select the preference and the display will immediately change to the requested preference.
ENTER, ENTER returns you to the menu screen.
2. Set Unlock Timeout, Press 2. This will bring you to a new screen.
“Press 1-5 for unlock timeout minutes” is displayed. CURRENT: 1 is the default. Press 2 for two
minutes, 3 for three minutes, 4 for four minutes and 5 for five minutes.
Enter-Enter returns you to the menu screen.