User's Manual

ID-TAD SPECIFICATIONS:
Battery: 4.2 VDC (3.7 VDC nominal) 1600mAh Lithium Ion battery pack. (DO NOT attempt to
repair or rebuild/replace the cells within). An iDTAD comes with and requires a Custom
Rechargeable Lithium Ion battery pack to operate.
Charging Cable: USB Type C - charges via a computer USB port or a 120VAC to 5VDC/500 mA
Adapter (not included) Note: using a charger that provides less than the recommended 500 mA
can work but will take longer than normal to charge.
MECHANICAL:
Size: approximately 5.50” x 3.00” x 1.25” (with boot)
Weight: 7 ounces
OPERATING CHARACTERISTICS:
Transmit Frequency: 127.0 kHz
Receive Frequency: 418 MHz
FCC ID: JM7-HWHY-662015
Canada IC: 2683A-662015
Internal Security Tag Transmit Frequency: 418 MHz
Internal Security Tag Receive Frequency 127 to 137 KHz
FCC ID: JM7-IGWT-662002
Canada IC: 2683A-662002
ENVIRONMENTAL:
Operating Temperature: 32º to 120º Fahrenheit
Intended for indoor use only.
Removing the battery
1. Always disconnect and remove the USB Cable
CAUTION: When you disconnect a cable, pull on its
connector or on its pull-tab, not on the cable itself.
2. Remove the Battery Cover
3. Remove the four Philip’s Head Screws
4. Separate the Rear Cover
5. Carefully remove the battery pack from the compartment
5. Carefully unplug the battery pack terminal from the main
Board connector
6. Properly dispose of the used LiON Battery Note: Consult
your bio-med department, or your local municipality
regarding location(s) for safe disposal and proper methods
Installing the battery
1. Install the new battery plug terminal to the main board.
(Black – left, Yellow – Center, Red – Right)
2. Replace the cover and secure with the four Phillip’s Head Screws
3. Replace the Battery Cover
4. Charge the New Battery/Unit for at least 4 hours before using.