User's Manual

Innovation First, Inc.
Operator Interface User Guide
10.31.2006 www.InnovationFirst.com Page 4
4. FCC / Industry Canada Certification and Warnings
This equipment has been tested and found to comply with the limits for radio controlled devices,
pursuant to applicable portions of FCC Part 15 and Industry Canada RSS-210 for license-exempt (i.e.
unlicensed) low-power radiocommunication devices. These limits are designed to provide reasonable
protection against harmful interference.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.”
Warning: Changes or modifications not expressly approved by the party responsible for compliance
may cause interference and void the user’s authority to operate the equipment. There are no user
serviceable parts inside.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
5. Operator Interface Indicators
The Operator Interface has the following indicators, as labeled on the cover.
Table 5.1: Operator Interface Modem LED States
Indicator State Description
All Solid Off No power to radio, cable not connected, OI turned off.
Standby Solid Off Check the Transmit and Receive LEDs.
Standby Solid On Not a valid state.
Standby Blink Modem being configured by OI.
Transmit Solid Off Modem not transmitting. Check Standby LED.
Transmit Solid On Not a valid state.