Owner Manual

17
MY WARRANTY HAS EXPIRED
InnovaSpa (Lumi-O | Innovaplas inc) will continue to provide service for your spa even after your warranty has expired via our
customer care center at 1-866-995-8646, extension 226.
DRAINAGE FREQUENCY
The frequency of draining your spa and cleaning or replacing your filter will be determined by your sanitation program. Consult
your dealer for recommendations.
BLEEDING AIR FROM YOUR SPA
When draining and refilling your spa, air may enter the pump which will keep the water from flowing into it. Below are the steps to
take to bleed an air-locked pump:
1. Turn off the GFCI breaker
2. Open the access door to the equipment enclosure.
3. Loosen a heater union until you hear the trapped air escape.
4. Once water drips out in a continuous stream, hand tighten the union until the water stops leaking.
5. Turn on the GFCI breaker.
6. Turn on all pumps to make sure that the pump starts and that there are no leaks.
7. Put the access door back on.
TROUBLESHOOTING
figure 1.13 : heater uniOn; lOOsen up tO bleed air