Specification

INSTALLATION INSTRUCTIONS
Remove the aerator from the end of
the spout.Turn on hot and cold water to
flush water lines.Allow water to run for one
minute.Turn off water and replace the
aerator.
3
Connect and tighten the supply hoses, refer
to a, b, c. Then check for leaks.
2
a.
b.
c.
Hold the Quick Nut (11) ,turn the nut counter
clockwise for two rounds.
Pull Quick Nut (11), and Rubber Washer (8)
down, to disassemble the nut.
4
8
11
8
11
Slide Rubber Washer (8), Quick Nut (11) up
onto Shank under sink it.
Hold the Quick Nut (11) rotate the nut two
rounds to tighten the nuts.
1B
8
11
8
11
Pictures for reference only.
Pictures for reference only.
For quick nut disassembly
This is for quick nut installation.