Specification

Insert faucet, assemble Washer (8) and
Locknuts (9) onto Shanks (7) from the
underside of the sink, then hand-tighten firmly.
INSTALLATION INSTRUCTIONS
1A
Remove the aerator from the end of
the spout.Turn on hot and cold water to
flush water lines.Allow water to run for one
minute.Turn off water and replace the
aerator.
3
Connect and tighten the supply hoses, refer
to a, b, c. Then check for leaks.
2
a.
b.
c.
You can install this faucet using standard faucet nut or Quicknut.
Below instruction is for normal mounting nut installation.
If your faucet came with Optional Quicknut, please see next page for Quicknut installation.