User guide

Page 23
Genesis II Installation Instructions
© Mass Electronics Pty Ltd 2010Chapter 2 – Mechanical Installation
2-2.2.4 REM Multipoint Modules
REM Multipoint Modules provide additional Analogue/Digital output capabilities for a Genesis II Series
digital controller.
There are a total of three dierent REM Multipoint Modules.
• GENII MP405 REM Multipoint Module
• GENII MP423 REM Multipoint Module
• GENII MP432 REM Multipoint Module
Common Enclosure Information
The above listed REM Multipoint Modules are housed in a rectangular case suitable for DIN Rail
mounting. The housing is moulded from flame retardant plastics recognised by UL as UL 94-V0.
Colour: Grey
Dimensions(max): 107mm(w) x 100mm(h) x 65mm(d)
Mounting: DIN Rail Mounted
The cable run between a digital controller and REM Multipoint Modules should not exceed 600
metres. However, the maximum cable length can be increased through the use of Innotech Repeater
IR11 module. Refer to Paragraph 5-3.3.3 for more information.
Below is a schematic of the GENII MP405 REM Multi Zone Station Module. The above listed REM
Multipoint Modules feature the same dimensions and similar appearance. Refer to Figure 2-7.
107
36
DI
4
DI
1
DI
2
DI
3
+
-
Comms
Jumpers
A2 A1 A0
EOL
SHLD2 SHLD1
TH2
TH1
+
-
+
-
+
-
+
-
Co mNO
DO 1 DO 2 DO 3
0V
24V
Co mNO Co mNO
+
AO
-
1
+
AO
-
2
E
7
90
50
36
65
12
100
Figure 2-7: GenII MP405 REM Multipoint Module