Installation Notes

1. Initialization state:
After the battery is installed and powered on, the blue indicator light is always on, and the product enters the
initialization state; if the Zigbee module is successfully initialized, the blue indicator light is off, and the product
enters the normal working state;
2. Normal work:
When the product is working normally, it is in the monitoring state, and the indicator lights are not on;
When the detected water level exceeds a certain height, the red indicator light of the device will flash, and the
alarm information will be uploaded.
3. Network function operation:
(1) Pair Zigbee gateway:
Open the APP, select the Zigbee gateway, click to add a sub-device, then long press the device pairing key for
5 seconds, the blue LED indicator flashes continuously, the device resets, and automatically sends a network
access request to the Zigbee gateway. After the Zigbee gateway confirms, it can be completed. Access the
network, and the APP will prompt the device to be added successfully.
The longest configuration time is 2 minutes. If overtime it will automatically exit the code matching mode.
(2) Test function
When the detector is monitoring normally, short-circuit the two-pole probe. If the network alarm information is
received, it means that the communication between the water leakage and the network platform is normal. The
same operation, but does not match the above phenomenon, the test fails. Indicates that the product has not
been paired (needs to be paired again) or the network communication has failed.
4.Low pressure alarm:
After the initialization is successful, the battery will be uploaded every 4 hours. When the battery voltage of the
product is lower than the set value, the power will be uploaded every 1 hour; platform alarm: at least 1 low-voltage
alarm prompt everyday; until the battery voltage can meet the normal operation of the product.
1. Do not install the detector in a place where water is already submerged.
2. When the equipment has a low voltage alarm, please replace the button battery of the same type in time.
Notice
Operation and adjustment