User's Manual

iCOM_WM05_AN Module EVB_QSG
REV 0.1 8/14/2015
The steps are similar to other rates as well.
For TX measurements go to ‘TX’ tab. Before starting TX operations following settings need to
be done on the GUI.
 TX Mode: Select ‘Packetized’
 Rates: Select the modulation rates want to transmit
o 11b: 1, 2, 5.5 and 11 Mbps
o 11g: 6, 9, 12, 18, 24, 36, 48 and 54 Mbps
o 11n: MCS0 to MCS7
 Channel: Select the channel of transmission. Channel 1 (2412M) to channel 13 (2472M)
 Data Pattern: Select ‘All 0’
 Power: ‘0’ for max power level the device can transmit at. Always use power level “0” for
emission testing in order to verify the max power level settings.
 Preamble: Select ‘Long’
 Override CCA: Should be unchecked
 Size: 100 Bytes (for 11b rates), 1000 Bytes (for 11g rates) and 1000 Bytes (for 11n rates)
 Delay: 100msec
 Tone: 0
 Amount: 0
7. Once the above setting are done, start TX by clicking ‘Start Tx Testing’