User's Manual

iCOM_WM05_AN Module EVB_QSG
REV 0.1 8/14/2015
6. Go back to ‘CC31x Flash Setup and Control’ and click ‘Program’
After programming the device remove programmer jumper. This removal is VERY important before
any testing to be done.
Reset the board using the RESET push-button
 Radio tool (to control the device):
1. Once the device is powered up (after connecting uUSB cable to ‘power jumper’), one
COM port should be enumerated in the device manger. Incase windows is not able to find the
device drivers then the drivers need to be installed separately. With the SDK0.51 package
installed, the driver should be available in below location.
2. Assuming (in the ‘required installation’ section), ‘CC3XXXRadioTool-0_5.exe’ is already
installed, invoke ‘CC3XXX Radio Tool’ from ‘All Programs -> Texas Instruments ->
CC3XXXRadioTool-0.5 -> CC3XXX Radio Tool.’