InnoComm Mobile Technology Corporation 3F, No. 6, Hsin Ann Rd., Hsinchu Science Park, Hsinchu 30078, Taiwan TEL: +886-3-5781868 FAX: +886-3-5781187 BT4.
Introduction This document describes pin definition, mechanical drawing and reflow data of Bluetooth Low Energy Module and hope it can helps designer to design in easier and manufacturing smoothly. Pin Definition Pin # Pin Name Direction Voltage Desription 1 VDD I 1.8 to 3.3V Input power can range from 1.8V to 3.3V 2 VSS I GND 3 TEST0 I/O 1.8V to 3.3V Mfg Test pin 0; MODE "POINTER". Internally pulled-up (active low) 4 TEST1 I/O 1.8V to 3.3V Mfg Test pin 1; MODE "JOYSTICK".
Mechanical Drawing Reflow data
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.
