User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
First Draft - CISCO CONFIDENTIAL
8-6
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-02
Chapter 8 5-GHz Radio Module Upgrade
Installing a 5-GHz Radio Module
Step 5 Tighten the 5-GHz radio module mounting screws using the supplied Torx L-wrench (see Figure 8-5).
Figure 8-5 Location of Mounting Screws
Step 6
Remove the backing paper from the 5-GHz radio product compliance label.
Step 7 Carefully attach the label in the space provided below the product compliance label (see Figure 8-6).
Figure 8-6 5-GHz Radio Product Compliance Label
1 5-GHz radio module antenna 2 Mounting screws
2 2
1
74630
1 5-GHz radio product compliance label 2 Access point product compliance label
1 2
74246