Step 4 Parts list SINGLE LEVER KITCHEN FAUCET INSTALLATION INSTRUCTION NO.
RECOMMENDED TOOLS The tools might be applied to the following places: Tools You Will Need: AS © EEE : WARNING: Plumber's putty Pipe tape i A { Please esp thi : | tools for future i : fuse! Philips Screwdriver pliers Adjustable wrench Allen key 3 » » Notice 1.Cleaning Before installation, shut off the water supply valves and clean up the water supply system. 2.Mounting hole Make sure the mounting hole size is between (¥33mm35mm as show in the diagram. 3.
Step Faucet installation Note:To make sure that // the pull out hose go _ = back semimonthly need 5 o Iris to adjust the weight in , right position 1.Put the faucet washer through the faucet 2.Connect the shower hose to quick connect. threaded sleeve and position the faucet in order Dis-assemble the weight and put is on the on the counter top as shown, Assemble gasket shower hose. assembly and lock nut to faucet threaded sleeve Then fix screws by screw driver.
Maintenance: temperate the faucet gently in order for a sustainable use. 2.Always blot dry any water from faucet surface.Clean with a damp non-abrasive sponge and wipe it with a clean soft cloth should be helpful to maintain good finish of the faucet. To remove water spots,apply warm water and a soft cloth. Make certain to rinse thoroughly with water immediately after cleaner. 3.Although the finish is extremely durable,it can be damaged by some cleaners.
Step Checking and testing Note:Don't lost the O-ring filter. 1.Remove the shower by hand. Turn the faucet 2.Check all connections at arrows for leaks, handle all the way on,turn on hot and cold water re-tighten it if necessary. supply and flush water lines for one minute. Reinstall shower by hand.
