Installation Guide

ibwellness.com
Chair Manual
10
9
Chair Installation 1. Removing the chair and parts from the package 5HPRYHWKHFDUWRQ
Foam
/HIWDQGULJKWVKRXOGHUDUHSXWLQ WKHVHWZRSRVLWLRQVVHSDUDWHO\
a. Lift and remove main outer carton. b. Remove cardboard and foam on both sides of the massage chair. c. Remove accessory box (includes: instructions, power cord etc.). 2. Installing the side panel
Foam
$LUEDJDLUWXEH
Iron plates inserted
LQWRWKHVHDWIUDPHDW
WKHUHOHYDQWVLGHVHDW
/RFNVFUHZSODFH
/RFNVFUHZSODFH
Iron plates inserted LQWRWKHVHDWIUDPH
a. Remove the side panels from the carton, and take them out to
begin assembly.
b. Connect the side panel airhose with the airhose coming out of the side of the
chair. Both sides of the airhose need to be inserted in order to prevent an air leak and loss of pressure during use.
c. Unscrew bolt (B) from the side panel, insert the metal connector plates
into the metal pipe which is on the corresponding side of the seat frame (as shown above). At the same time, put the other bolt (A) in the slot on the corresponding seat frame. Then align the holes and screw in bolt (B). Tighten the two screws and repeat this process on both side panels.
d. Smooth out the fabric of the chair.
Product Components MAIN BODY DIAGRAM (REAR)
Remote Controller Port Main Power Switch Safety Fuse Power Cord Socket