User's Manual

INNCOM PC-502 Datasheet P a g e | 3
S5bus
GS-528H E528.3G
PC-502.2
S55x Lamp
Controller
L208 Lamp
Controller
X07 HVAC
Controller
Layer-1 RF Network
Layer-2 RF Network
TCT.RF
Ethernet
B573-MBX
Figure 4 PC-502 Layer-2 Topology
In this application, the PC-502 in participation with the e528.3G provides the Layer-1 to Layer-2 RF Bridge where
both wireless in-room and wireless back-end networking are required. The PC-502 can also patch areas within the
Layer-2 network where signal strength is lost due to distance limitations or interference.
Safety/Regulatory
Parameter
Condition
Status
FCC
Part 15b
This device contains FCC ID: FCC ID: GTC202125TXR
Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This
equipment should be installed and operated with minimum distance 20 cm between the radiator& your body
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off