User's Manual
2
Copyright 2014 INNCOM by Honeywell
Specifications
Parameter
B578
RF Data Rate
250kbps
Indoor/Urban RF range
100ft
RF Transmit Power
50mW (+17dBm)
RF Receive Sensitivity
-97.7dBm
Frequency Band
2.4Ghz
Encryption
AES-128
Protocol
802.15.4
Frequency Channels
11–26
Network Topology
Mesh
Maximum devices per IP network segment
50 B578 PAN coordinators; 2000 PC-803 room gateways; 200 Edge Routers
Maximum devices per RF mesh network
Up to 200 (depending on application profile and site situation)
Maximum in-room devices per room
Up to 50
Supply Voltage
12VDC
Current Consumption
200mA peak, 100mA RMS
Operating Ambient Temperature
0–40 °C
Dimensions
86mm x 78mm x 40mm (DIN rail mount); 20.65mm x 22.25mm (wall mount)
Agency Approvals
FCC Part 15, CE Mark ETSI, RoHS
This device contains FCC ID: GTC201104TXR.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. Modifications not expressly approved by
INNCOM International Inc. could void the user’s authority to operate the equipment.