User Manual

42 / 64
 Never restart and ride your INMOTION SCV after it has indicated an empty Battery or performed a Safety Shutdown
due to low Battery. The INMOTION SCV may not have enough power to keep you balanced, especially if you accelerate,
which requiresmore power.
 If you restart and continue riding after a Safety Shutdown due to low Battery, you risk falling. Also, you risk damaging
your Battery Pack, resulting in reduced Battery life and capacity.
 When wheel slip or procedure errors, the wheel will be spinning. Immediately lift SCV and hold it upside down (the
direction of the handlebar tilt 30 ° and above) until the wheels will stopspinning. If still this can not control SCV, please
remove the battery, and then re-install it.One of the ways that the INMOTION SCV notifies you when you are at risk of falling
is by vibrating and releasing a warning sound.
The following chart shows situations that trigger a Shaft Shake Warning, and recommended actions:
Possible Causes
Recommended Action
Riding aggressively, accelerating or stopping abruptly.
Ride smoothly.
Riding against the Handlebar to speed up.
Leave a gap between yourself and the handlebar.
Riding on rough terrain or steep slopes.
Ride on smoother and flatter terrain.
Riding backwards too quickly.
Stop, turn in place, and proceed forward.
Safe Stop has been triggered.
Come to a controlled stop and safely step off the
Powerbase within 14 seconds.
Pulling the INMOTION SCV too fast in the Assist
Mode.
Stably drag INMOTION SCV.