User's Manual

DRAFT
5: Evaluation tools
5.2.2.5:UART Interface
UART interface is implemented with single row 6 way pin header CN1007. Applied interface is
commonly used interface and allows commercially available USB/UART cable e.g. FTDI TTL-232R-
3v3 adapter cable. Pin header type is Harwin M20-9730645. Signal order in pin header is shown in
following Table 20 . Pin organization is shown in Figure 21 .
Pin Control Description
#1 GND
#2 NC
#3 NC
#4 RXD Received data
#5 TXD Transmit data
#6 NC
Table 20. UART interface signals
Figure 21. UART interface pin organization
5.2.2.6:Audio interfaces
The evaluation module has two audio interfaces. Analog audio interface N1000 is 3,5mm standard
mono jack SJ-3523-SMT from CUI Inc providing audio in, audio out and GND. Signal order in analog
audio interface is shown in Table 21 .
Pin Signal Description
#1 Tip an_Au Ext Ear Analog audio output
0.53Vrms (load 16 ohm)
#2 Ring an_Au Ext Mic Analog audio input
1.5 Vpp (0dBFS, 0dB gain)
#3 Sleeve An_Au GND
Table 21. Analog audio interface signals
Another audio interface XCN1004 is 2 row 10 way pin header Harwin M20-9720545 which provides
both analog and digital audio interfaces for VAM control. Signal order in pin header is shown in Table
22 . Pin organization is shown in Figure 22 .
Pin Signal Description
#10 AN_AUD_EXT_MIC Analog audio input
#1 AN_AUD_EXT_MIC Analog audio input
29:GSPS Core Module 2.0 VAM-CM HW Description
Confidential and Proprietary – Inmarsat Global Limited
inmarsat.com