Installation Instructions

Table Of Contents

4.3 Route cables into vehicle

The cables can now be routed into the vehicle. In many vehicles, the door

seals are sufficiently pliable that they will not damage the cables when the

door is closed.

4.4 Affix RF cables to clip with cable tie

For added cable strain relief, use the provided cable tie to firmly secure the

short RF cables on the clip adapter to the clip adapter body.

4.5 Connect 1.5m RF cables to clip adapter

When connecting cables to the clip adapter, care needs to be taken to connect

to the correct ports: match the cable connected to the GPS port on the antenna

to the GPS port on the clip. And likewise, match the cable connected to the

ISAT port on the antenna to the ISAT port on the clip.

If the cables are inadvertently cross-matched, there will be no signal

bars on the phone when it is powered up. Check that the cables

match the antenna and clip ports end-to-end.

4.6 Insert phone into clip

Insert the phone into

the clip as follows:

1. Open rear connec-

tor access panel

(see figure below)

2. Snap bottom of

handset into clip

adapter

3. Engage connectors

into the handset

and clip adapter to

handset