Installation Manual

Loosen the bolt holding in the air box snorkel using
10mm socket and extension.
Remove the gasket from the resonator.
Lift up stock intake and remove from vehicle. Remove the air box snorkel guard from the vehicle.
Loosen the clamp on the turbo using 7mm nut driver.
Pull back the second grommet on the back of the air
box.
Stock box shown in this picture
Pull back drain plug from the bottom of the air box.
Disconnect MAF sensor harness.
Pull back the front grommet from the bottom of the air
box.
Carefully remove the bumper cover, this requires 2
10mm bolts on top, push-clips, and t-25 screws
located on the bottom of the vehicle. This is
required for the cold air installation.
Pull back the air box snorkel from the resonator.
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13 Figure 14
Page 2 of Part# SP7029