Owners manual

Remove the clips holding in the resonator scoop on
vehicle frame.
Pull out the complete air box assembly. Make sure the
lines are apart from the intake tube.
Carefully pull back clip located on the radiator splash
guard holding in the resonator scoop.
Pull back crank case line.
A) Loosen the screw holding in air box using 10mm
wrench or socket.
B) Carefully pull back the stock intake tube from the
turbo.
Stock box shown in this picture. Remove engine cover.
Disconnect negative battery terminal.
Pull back smaller vacuum line from intake tube.
Disconnect the vacuum line from the intake tube.
Loosen the 3 bolts holding in the air box using 8mm
socket or nut driver.
Remove the front bumper cover. Loosen and remove
clips and screws on top, side and bottom of cover.
Carefully remove the cover.
Now remove the resonator scoop from the air box
bracket.
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Page 2 of Part# SP5040
A
B
A) Loosen the 2 nuts using 13mm socket or wrench hold-
ing in the air box bracket.
B) Pull back any lines that are attached to the air box
bracket.
Figure 14
A
B