Owners manual

Install the intake tube and position through the hole on

the heat shield. Position the bracket to the vibra mount

and to the straight hose.

Now secure the bracket using provided washer and

nut. Now position the intake tube for the best fit and

tighten.

Secure the front of the heat shield using the factory

screws. Tighten using T25 torx bit.

Install the 3-1/8” hose with clamps to the MAF sensor

do not tighten.

If not equipped with smog pump, cap off using vinyl

plug.

Now secure the tab using provided allen screw and

fender washer.

Install the provided vibra mount to the heat shield with

vibra mount closes to the engine. Secure using provided

m6 nut.

Attach the rubber trim to the top of the heat shield.

Tighten using 10mm wrench.

Install the heat shield and position the bracket to the

original air box screw location. Also position the front

of the heat shield to the holes from step 12.

Tighten screw using 6mm allen key.

Now connect the smog pump harness to the fitting on

the intake tube, if equipped.

Figure 15

Figure 16

Figure 17

Figure 18

Figure 19

Figure 20

Figure 24

Figure 25 Figure 26

Figure 23

Figure 22 Figure 21

Page 3 of Part# SP3075