Owners manual

WithT25 torx bit loosen the 2 screws holding in the fac-
tory ram scoop and remove. Save screws for later
install.
Attach the vinyl trim to the inside of heat shield hole
cut out for the intake tube.
Use a T25 torx bit screwdriver and loosen the upper
half of the airbox and remove.
Complete OEM air box removed.
Pull back the MAF sensor and set back.
With pliers, carefully pinch clamp and pull intake
tube away from air box.
Stock box shown in this picture
With T25 torx screw, loosen the 2 screws holding in
the MAF sensor.
Pinch the harness on smog pump and pull away from
air box. (if equipped with smog pump)
With T30 torx bit, loosen the screw holding in air box.
Now, lift up and remove the bottom half of the air box.
Rotate the smog pump fitting, if equipped, for the
position of the new intake.
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13 Figure 14
Page 2 of Part# SP3075