Owners manual

12. Now install the rubber trim to the heat-
shield. Cut a notch in corner for easier installa-
tion.
16. Secure and tighten both screws
using 10m socket or wrench on heatshield.
15. Secure the tab to the front of the ra-
iator support. Locate the thredded insert
and secure using provided M6 screw and
fender washer.
17. Install the intake tube and position the
tube to straight hose and bracket to vibramount.
20. Secure and tighten the clamp on
turbo housing.
14. Secure the bottom of the heat-
shield to the thredded insert on vehicle
frame using provided M6 screw with fender
washer.
18. Secure the vibramount using provided
M6 nut and fender washer, tighten using 10mm
socket and fender washer.
22. Re-connect the MAF sensor
harness.
21. Position the intake and tighten the
bracket using 10mm socket or wrench.
Instruction Manual P/N:SP1572
13. Install the heatshield into the
vehicle and position.
23. Install the filter and tighten clamp
using 8mm nut driver.
Page 4 SP1572
19. Install the MAF sensor into the in-
take tube. Secure using factory screws and
tighten.