Owners manual

1. Stock intake system shown.
4. Remove the sensor from the air box. Save
screws for later install.
3. Using phillips screwdriver, loosen the
2 screws holding in the MAF sensor.
5. Loosen the 2 bolts holding in the air box and
remove. Lift up and remove the complete stock air box
assembly out of vehicle.
8. Now install the M6 vibramount to the
thredded fitting on the provided bracket.
Secure and tighten.
7. Loosen the clamp on the turbo
housing using phillips screwdriver.
6. Locate the bracket on the engine
holding in line. Pull back harness and
loosen the bracket using 10mm socket or
wrench.
10. Install the 2-3/8” straight hose with
clamps to the turbo housing. Tighten the
clamp on the housing only.
9. Now install the new provided bracket to
the engine, secure using the original screw.
Tighten using 10mm socket or wrench.
MAF sensor
Instruction Manual P/N:SP1572
2. Disconnect the MAF sensor.
MAF sensor
11. Install the vinyl trim to the hole cut out
on heatshield.
Page 3 SP1572
7. Remove the bracket from the
vehicle. Save screw for later install.