Owners manual

Pull the metal CCV / coolant line out of the lower air box
assembly
Use a 10mm socket and rachet and loosen the two 10mm
bolts connecting the lower air box assembly to the engine.
Use a 5.5mm socket and rachet and loosen the
clamp onthe lower air box assembly air duct to
throttle body. Then continue to loosen the clamp on
the throttle body side.
Release the four metal tabs attaching the lower and upper
air box assemblies.
Pull the upper air box assembly off of the lower assem-
bly
Picture of factory air intake system
Disconnect the MAF sensor harness
Figure A: Use a phillips screw driver and loosen the
two screws on the MAF sensor. Figure B: Pull the
MAF senosr out of the air box housing. This sensor
will be reused in this intake kit.
Firmly pull the rubber air duct off the front of the lower
air box assembly.
Page 2 of Part# SP1570
Press on the release tabs on the MAF sensor harness
plastic channel to remove the harness from the air box
assembly.
Figure 3
Figure 4
Figure 5
Figure 6 Figure 7
Figure 8
Figure 10
Figure 9
Figure 11
Figure 12
Remove the rubber throttle body air duct to air lower
air box assembly out
Now you may pull the entire lower air box assembly
out of the engine bay..
Figure 13 Figure 14
A
B