Owners manual

Make sure that the cable line is through the cut out on
cover and heat shield.
Secure and tighten the 3 screws using allen key.
Make sure that the filter has clearance and not touching
anything. Loosen and position anything if necessary.
Install cover and position to heat shield.
Install the intake tube and position to the hose and
bracket to the vibra mount on heat shield.
Install the filter and position for the best fit and clear-
ance.
A&B) Tighten and secure heat shield using the 10mm
socket and ratchet.
Position the hose to the hole cut out on the heat
shield. Tighten the clamp on the MAF sensor only.
Attach the 3-1/8” straight hose with clamps provided
to the MAF sensor.
Position for the best fit and secure the bracket using
provided washer and nut. Tighten using 10mm socket
or wrench.
Install the vinyl trim to the cutout on the cover.
Secure the cover using the provided stainless M6
screws.
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20
Figure 24
Figure 25 Figure 26
Figure 23
Figure 22 Figure 21
Page 3 of Part# SP1105
A
B