Owners manual

Secure the bottom of the heat shield using provided M6 nut
to the thredded insert located on the frame of vehicle.
Position the vibra mount to the Cruise control module.
Use provided hex screw and washer and secure the
bottom of the cruise control module using factory nut.
Tighten using 10mm socket or wrench.
A) Install the vibra mount to the hole on the inside of
the heat shield. B) With provided nut, secure the vibra
mount and tighten using 10mm socket and ratchet.
If equipped, Install the temperature sensor to the hole
cut out on the heat shield. Secure using provided hex
screw.
Carefully lift up and pull out the air box.
Attach the vinyl trim to the inside of the large hole on
heat sheild.
Un-clip MAF sensor and pull back.
Loosen the the M6 nuts holding the cruise control
module. Save the nuts for later install.
With 10 mm socket, loosen the screw holding in the
temperature sensor and pull back.
Pull out the air box grommet.
Attach the other vibra mount to the tab on housing.
Secure using provided nut and washer. Tighten using
10mm socket and ratchet.
Loosen the screw and nut, posititon the vibra mount
and secure using factory nut. Position the cable line
through the slot cut out on heat shield.
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13 Figure 14
Page 2 of Part# SP1105
A
B