Owners manual

Press the 3 1/2” filter neck over the intake as shown above. Once the filter has
been properly placed continue to tighten the filter neck clamp.
Lower the entire intake assembly into the engine compartment and press the top
end into the 2 3/4” straight hose.
Once the vibra-mount has been inserted into the hole use
the m6 flange nut and washer to hold the vibra-mount
from underneath the wheel well(A). The vibra-mount
should be firmly in place next to the cruise control box (B).
With-out pinching the O-ring on the MAF sensor,
press the sensor into the flange adapter and use
the stock screws to firmly attach the MAF sensor.
Page 3 of part# SP1726
Unscrew the stock screws and remove the mass air
flow sensor from the air intake box (A).
Slowly, insert the mass air flow sensor into the
machined MAF sensor flange as shown above (B).
>>>>
>>>>
(A)
(A)
The m6 flange nut and fender washer are used to
secure the intake bracket to the vibra-mount stud.
Take the stock 8mm breather hose connected at the
crank case port and press it overf the 1/2” intake port.
Use the stock clamp to secure the hose in place.
Gently, Press the top intake into the throttle body
hose, while aligning the intake bracket to the vibra-
mount stud.
Press the 27” 6mm vacuum hose over the the 3/8”
vacuum hose coming from the small intake
manifold port.
Press the 19” 10mm hose coming from the crank
case port over the the 1/2” intake port.
(A)
(A)
The bracket is lined up the vibra-mount stud.
B)
B)
(A)
(A)
(B)
(B)