Owners manual

Press the 2 3/4” straight hose over the throttle body,
place two .312 bands on the hose and tighten the band
on the throttle body side (A).
Insert vibra-mount into the hole near the cruise
control box. The hole is not tapped so a washer
and m6 nut will be used underneath.
Remove the entire stock air intake box and air intake duct. Disconnect the large
10mm hose by the firewall (A). The small 6mm hose connected to the intake
resonator will also come out intact (B).
Once you have removed the stock vacuum at the intake port replace it with the
19” 10mm vacuum hose (A).
Remove the 6mm bolt by the cruise control box in
order the remove the air intake box.
Disconnect the harness clip connected to the air
mass sensor.
Disconnect the stock 6mm vacuum line connected to the small intake manifold
port. This line will be replaced with the 27” 6mm vacuum hose.
Disconnect the stock 8mm breather hose connected to the air intake box
port. This line will be reused and connected to the first 1/2” port nearest
to the filter.
>>>>
>>>>
(A)
(A)
>>>>
>>>>
(A)
(A)
>>>>
>>>>
Page 2 of part# SP726
(A)
(A)
Prior to starting this installation, disconnect the negative battery terminal.
Remove the 6mm bolt located on the cross member. This
will allow you the remove the entire air intake box.
(A)
(A)
(B)
(B)
>>>>
>>>>
Press the 27” 6mm vacuum hose over thesmall intake
port as shown above. This line will connect to the 3/8”
center port nearest to the throttle body.
>>>>
>>>>
>>>>
>>>>
(A)
(A)